  |
|
    |
Installing | ||
|
Blinder XTreme M-40: Download Install Manual in PDF Format Blinder XTreme M-20: Download Install Manual in PDF Format Blinder XTreme M-10 TWIN: See below Content:  Important Mounting Self-Test function Electrical wiring Service and control Don't drive illegally How to use your new Blinder Specification Sheet |
 Blinder XTreme M-10 TWIN Laserjammer Installation package |
||
 |
|||
| Important The Blinder XTreme M-10 TWIN should be mounted facing the front or back of the vehicle. The Blinder XTreme M-10 TWIN should be mounted between the passenger side headlight (or taillight) and the driver's side headlight (or taillight). The on/off button and the beeper are of course placed inside the cabin of the car. |
|||
 |
|||
| Mounting Divide the front of the car in two half's. Install one of the Blinder's M-10 in the middle of one half, and then do the same on the other half. The distance between the two units must to be 50 - 60 cm. Blinder performs equally well when mounted horizontally or vertically with the lens in the forward direction. Please click here for Specification Sheet. |
|||
 The two Blinder units fits into the front of most cars. Here on the Dodge Neon used at Texas Field Test. |
|||
| Horizontally and vertically It is very important, that you mount the two Blinder M-10's very carefully. The two units must point straight ahead. Otherwise the detectors and jammers will not function optimally. Avoid positoning anything in front of, or obstruction the lens. The lens must project from, or lie flush with the grille. |
|||
 The two units must point straight ahead. That means horizontally to the road surface and parallel to the driving direction. |
|||
| Self Test Function When the ignition is turned on, the upstart self-test function will turn-on the in-carbine alert for two seconds telling you that the Blinder is ready to do its job. |
|||
Electrical Wiring |
|||
| Service and Control Keep in mind that snow and dirt that gets on the lens decreases the output of the Blinder M-10 TWIN's range to where it may not detect or jam the police laser gun when you need it. Keep the lens clean and as free of debris as possible. Scratches and stone damage can also affect output. If the lens becomes too badly damaged, order replacement lenses separately. |
|||
| Don't drive illegally We recommend against driving recklessly or above the posted speed limit and assume no responsibility for the actions of any person that purchases or uses the Blinder M-10 TWIN. We cannot replace your driving license, so drive legally, responsibly and carefully. |
|||
| How to use your new Blinder For avoiding any trouble with the police, we strongly recommend to follow the method mentioned below when dealing with police laser guns: At the moment when you hear the Blinder warning signal, you must at once: 1. Slow down if you are speeding 2. Switch off the Blinder In that way you will allow the police to get a clear speed measurement without making any attention. Sometimes the police need two or three shoots before getting a usable speed measurement. Therefore turn off the Blinder within a few seconds, and nobody will suspect that something is wrong! |
|||
Blinder XTreme M-10 Specifications |
|||